HOW TO FIX HP PRINTER ERROR 0XC18A0206

One of the most common errors faced in HP printer users is the error 0xc18a0206. Users often face this error, so here is a quick guide for you on how to fix HP printer error 0xc18a0206. Read the following article to resolve the issue with ease. In case, you need further assistance; you can approach the HP Printer Support and tackle the issue in no time!

Firstly, what is this is HP Printer Error 0xc18a0206?  #

The error 0xc18a0206 shows in the control panel of the printer and depicts an ink system failure error.

What are the reasons for this error? #

  • The entire setup of your HP printer is not installed correctly.
  • Printer cartridges low message.
  • Printer cartridge might be damaged and not inserted properly.

How can I solve the Error? #

Solution 1: Use authentic HP ink cartridges.

Solution 2: Printer rest

In some instances, taking out the ink cartridges and resetting the printer can resolve the error message.

  • Turn the printer ‘on.’
  • Have patience until the printer is idle and silent before you continue.
  • Now, disconnect the USB cable from the rear of the printer.
  • If the printer has any network or wireless connection, leave the printer connected to the network or the wireless connection.
  • Now, take out the ink cartridges from your printer.
  • Now, with the printer still turned on you should remove the power cord from the wall outlet and also the rear of the printer.
  • Hang around at least for 60 seconds.
  • Plug-in the power cord back into the wall outlet after that.
  • Please keep in mind that HP Printer recommends connecting the printer power cord directly to the wall outlet.
  • Re-connect the power cord to the rear of the printer.
  • Turn the printer ‘on’ again if it does not turn on automatically.
  • The printer may go all the way via a warm-up period.
  • The printer lights might flash, and the carriage might move.
  • Be patient until the warm-up period finishes and the printer is inactive and silent before you proceed.
  • Re-insert the ink cartridges and then shut the ink cartridge entrance
  • If you receive a message to print a calibration page, you should do the same.
  • If you by mistake disconnected the USB cable, re-connect it again to the rear of the printer.
  • Now finally, try to print.

Alternate method: #

Step1: Select * and # at the same time

Step2: Select 1, 2, 3 and “support R0632M” should display

Step3: Select > and “information menu” should display

Step4: Select > and “configuration menu” should display

Step5: Select OK and “hardware failure status” should display

Step6: Select OK “failure status: clear.” Press OK to clear

Step7: Select CANCEL

Step8: Turn the printer off, unplug the power cord for 2 minutes and plug cord back in then turn the printer back on.

Please contact the customer support of the HP printer in case the issue prevails. 

Related Issues #

  • How to Fix HP Printer Error Oxc19a0042
  • How to Fix HP Printer Error Oxc19a0040
  • How to Fix HP Printer Error Oxc19a0020
  • How to Fix HP Printer Error 0x61011beb

Powered by BetterDocs

Leave a Reply

Your email address will not be published. Required fields are marked *

Skip to content